Appendix C: Using the ARC Utility ● 78
● Direct attached drives—The connection is determined by the cable connected to a device,
for example CN1 (connector 1) is connected to DEV1 (device 1). For more information, see
Direct-Attach Connections
on page 61.
● Storage Enclosure Processor (SEP) managed devices—The connection is determined by an
active backplane. Box0 (enclosure 0) is connected to slot0 (disk drive slot 0 in the
enclosure). For more information, see Backplane Connections
on page 61.
● Expanders—The connections is determinded by an expander. Exp0 (expander 0) is
connected to phy0 (phy 0 within a connector). For more information, see SAS Expander
Connections
on page 61.
Note: Devices other than disk drives (CDROM, tape drives, etc...) are listed in order after your
system disk drives.
Viewing the Event Log
The BIOS-based event log records all firmware events, such as configuration changes, array
creation, and boot activity.
Some events are not stored indefinitely—the event log is cleared of any non-persistent events
each time you restart your computer; additionally, once the log is full, new events overwrite
old events.
To view the event log:
1 Start the utility (see page 69).
2 Select the controller you want, then press Enter.
3 When the utility menu appears, then press Ctrl+P.
4 Select Controller Log Information, then press Enter.
To Next Page
Loading...
