Adaptec ULTRA160 - Advanced Configuration Options

21
Configuring the Adaptec SCSI Card 29160 with SCSISelect
Advanced Configuration Options
Note:
Do not change the Advanced Configuration Options
unless absolutely necessary.
■
Reset SCSI Bus at IC Initialization—(Default: Enabled) When
set to Enabled, the SCSI card generates a SCSI bus reset during
its power-on initialization and after a hard reset.
■
Display <Ctrl> <A> Messages during BIOS Initialization—
(Default: Enabled) When set to Enabled, the SCSI card BIOS
displays the
Press <Ctrl> <A> for SCSISelect (TM) Utility!
message on
your screen during system bootup. If this setting is disabled,
you can still invoke the SCSISelect Utility by pressing <Ctrl>
<A> after the SCSI card BIOS banner appears.
■
Extended BIOS Translation for DOS Drives > 1 GByte—
(Default: Enabled) When set to Enabled, provides an extended
translation scheme for SCSI hard disks with capacities greater
than 1 GByte. This setting is necessary only for MS-DOS 5.0 or
above; it is not required for other operating systems, such as
NetWare or UNIX.
Caution:
Changing the translation scheme destroys all
data on the drive. Be sure to back up the data before
changing the translation scheme.
Use the MS-DOS
Fdisk
command to partition a disk larger
than 1 GByte controlled by the SCSI card BIOS, when using
DOS, Windows 3.1.x, or Windows 95/98.
■
Verbose/Silent Mode—(Default: Verbose) When set Ve r b o s e ,
the SCSI card BIOS displays the host adapter model on the
screen during system bootup. When set to Silent, the message
will not be displayed during bootup.
■
Host Adapter BIOS (Configuration Utility Reserves BIOS
Space)—(Default: Enabled) Enables or disables the SCSI card
BIOS.
■
Leave at Enabled to allow the SCSI card BIOS to scan and
initialize all SCSI devices.