2. Electrical Service Specifications
IMPORTANT: THE DRYER MUST BE CONNECTED TO THE ELECTRIC SUPPLY
SHOWN ON THE DATA LABEL THAT IS AFFIXED TO THE BACK
PANEL OF THE MAIN ELECTRICAL CABINET LOCATED IN THE
RIGHT HAND ELECTRICAL ENCLOSURE.
WARNING: 208 VAC and 230 VAC ARE NOT THE SAME. Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE: ADC reserves the right to make any changes in specifications at any time without notice
or obligation.
310 (GAS) Tilting
Gas 15 HP Blower Motor / 5 HP Drive Motor
IMPORTANT: 208 VAC AND 230 VAC ARE NOT THE SAME. When ordering, specify exact voltage.
NOTES: A. Fuse ratings are dual element, time delay, current limiting, class RK1 or RK5 ONLY.
B. Circuit breakers are thermal magnetic (industrial) type ONLY. For others, calculate/verify correct
breaker size according to appliance amp draw rating and type of breaker use
C. Circuit breakers for 3-phase (3ø) dryers must be 3-pole type.
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP
DRAW
MINIMUM
WIRE
SIZE*
FUSING
CIRCUIT
BREAKER
Dual Element
Time Delay
208 3ø 3/4 60.7 #4 80 90
230 3ø 3/4 55.1 #6 80 90
380/400 3ø 3/4 33.9 #8 50 70
416 3ø 3/4 32.9 #8 50 60
460/480 3ø 3/4 28.6 #8 50 60
* AWG Stranded Type Wire ... for individual lengths less than 100 feet (30.48 meters).
Motor lead type wire is recommended.
To Next Page
Loading...
