ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
2-284
© 2000, ADC Telecommunications, Inc.
TAD-105
Page 8 of 8
Table 105-1. TL1 Commands, continued
COMMAND DESCRIPTION
TEST ACCESS COMMANDS
CONN-TACC-T1 Connect Test Access T1
DISC-TACC Disconnect Test Access
CHG-ACCMD-T1 Change Access Mode T1
CHG-TSTSIG-T1 Change Test Signal
DISC-TSTSIG Disconnect Test Signal
CHG-LPBK-T1 Change Loopback Signal
MEAS-SIG-T1 Measure Incoming DS1 Signal
DISC-MEAS Terminate a Measurement
REPT-RSLT Report Intermediate Measurement Results
TST-INSERRBITS Insert Data or Frame Bit Errors in Test Signal
To Next Page
Loading...