ADC Sound Shaper Three - Disassembly Instructions

METER SWITCH "IN"
BY-PASS/EO SWITCH TO "EO"
INPUT
BY-PASS
r--------------------,
I I
~-------------------+~ ,
>--!,-----i
I
,
,
,
,
,
, I
~ J
SIGNAL GAIN CONTROL
COMPARATOR
EQUALIZER
L..-.-+---!a SIGNAL GAIN
CONTROL CIRCUIT
01003
(01005)
01002
(01004)
SIGNAL GAIN
LED
Figure 9
WHEN BY-PASS SWITCH IS "IN" AND METER SWITCH IS "OUT", SIGNAL GAIN CONTROL
LED DOES NOT INDICATE REGARDLESS OF INPUT SIGNAL.
DISASSEMBLY INSTRUCTIONS
1) To remove chassisfrom metal cabinet
a) Remove four screws - two from each side of cabinet asshown in Figure A.
b) Remove five screws that fasten the rear panel to the metal cabinet. (See Figure B.)
2) Removal of Front Panel
a) Remove chassisfrom metal cabinet asdescribed in 1).
b) Remove the four screws from the top (Figure C) and four screws from the bottom (Figure D)
of the Front Panel.
c) Remove knobs and pull panel off.
NOTE: If required, remove one screw (painted red) from the top of the Front Panel as shown in
Figure E.
Figure A
Figure C
Figure E
Figure B
Figure D
-12-