ADCMT 6247G - Scanner Control

6247G/6247C DC Voltage Current Source/Monitor Operation Manual
5.2.10 External Control Signals
5-58
5.2.10.2 Scanner Control
This section shows an example of controlling the 7210 scanner.
In this example, the measurement is performed in the pulse source mode and the channels of the 7210 are
switched by the COMPLETE OUT (END) signal. The following shows the connection diagram and the
timings.
Figure 5-15 Scanner Control
(*1)
(*1) Set the output pulse width to 100 s.
Source/
measurement
(6247G/6247C)
(6247G/6247C)
Tp
(6247G/6247C)
CH switching
(7210)