ADCMT 6247G - Page 79

6247G/6247C DC Voltage Current Source/Monitor Operation Manual
2.3.4 Default Parameters
2-51
2.3.4 Default Parameters
The following table shows the parameters saved in or loaded from the non-volatile memory and their
default values.
Table 2-2 Default Parameter List (1 of 4)
Parameter Default value
Always saved
Interface USB
GPIB Address *2 01
Talk Only/Addressable Addressable
USB ID 001
Header output *1 ON
Baud rate *3 9600
Parity *3 None
Number of data bits *3 8 bits
Number of stop bits *3 1 bit
Parameter loading at power ON P.OFF
Saved in non-volatile
memory areas 0 to 3
Source function VS
Parameters for VS
Source value (pulse value) and range +0.0000 V
HI/LO limit values and range +320.0 mA/-320.0 mA
Bias value and range +0.0000 V
Start value and range +0.0001 V
Stop value and range +0.0100 V
Step value and range 0.0001 V
Level value and range +0.0000 V
Sampling count 0001
Start address 0000
Stop address 0000
First value and range +0.0001 V
Middle value and range +0.0100 V
Last value and range +0.0200 V
First step value and range 0.0001 V
Second step value and range 0.0001 V
Source range setting mode FIT/LOCK FIT
DC pulse base value and range +0.0000 V
Pulse sweep base value and range +0.0000 V
*1 Not saved in remote control
*2 6247G
*3 6247C