Need help?Do you have a question about the Addictive audio 50.1D and is the answer not in the manual?
Details on mounting location, wiring, and ensuring proper air circulation.
Explains +12VDC, Ground, and Remote connections with recommended wire gauges and fuses.
Describes connecting the positive battery terminal with appropriate fusing.
Details secure chassis grounding using an "O" ring and proper wire gauge.
Provides a caution for the order of power and ground connections.
Illustrates speaker wiring for various subwoofer setups and impedance loads.
Adjusts input gain to match source unit output; not a volume control.
Controls high-pass crossover for speaker outputs, eliminating ultra-low frequencies.
Controls low-pass crossover for speaker outputs, reducing unwanted upper frequencies.
Explains the function of the Power (Green), Protection (Red), and Clipping (Yellow) LEDs.
Explains +12VDC, Ground, and Remote connections with recommended wire gauges and fuses.
Illustrates speaker wiring for various subwoofer setups and impedance loads.
Adjusts input gain to match source unit output; not a volume control.
Explains the function of the Power (Green), Protection (Red), and Clipping (Yellow) LEDs.
General| Channels | 1 |
|---|---|
| RMS Power at 1 Ohm | 5000W |
| RMS Power @ 1 Ohm | 5000W |
| Frequency Response | 10Hz - 250Hz |
| Low Pass Filter | 35Hz - 250Hz |
| Subsonic Filter | 10Hz - 50Hz |
| Phase Shift | 0 - 180° |
| Signal to Noise Ratio | 90dB |
| Input Sensitivity | 0.2V - 6V |
| Bass Boost | 0 - 12dB |
| Efficiency | 85% |
To Next Page
