(5) When the screen returns to the calibration menu, the 2 option will change to This shows the calibration.
nd
is complete.
Note t similar to that the: hree-point pressure calibration is the two-point. The only difference is icons
.will display while the zero is calibrated
9.3 Cancel calibration
Select to cancel the calibration then the screen will display .and push ,
10. Power supply description
The ADT681 has two power sources: a 9V alkaline battery(ANSI/NEDA 1604A or IEC 6LR61) or special DC9V
adapter.
(1) Standard type:
Figure Battery installation diagram10-1-2：Figure Connect the adapter diagram10-1-1：
()1()2
()3()4
34
To Next Page
Loading...
