1007: The parameter settings are irregular
1016: The current data is not the range of zeroing
1017: The number of parameters entered does not meet the parameter settings
1018: This instruction is non existent-
1019: The length of the operation code is too long
1020: The r/w of instruction is wrong
1024: The setting of pressure unit is irregular
1025: The serial port's address code is too long
1026: The baud rate is wrong
1029: Some parameter codes are too long
1.4 The series port's communication collocation
The protocol supports two types of address format as following:
1. 1-byte address, the address is a hexadecimal. Example:
[0x01]: R: MRMD: [terminator], the terminator is 0x0x0, 0x0a or 0x0d;
2. 3-byte address, the address is a string. Example:
[001]: R: MRMD: [terminator], the terminator is 0x00, 0x0a or 0x0d;
[255]: R: MRMD: [terminator], '255' is a universal address. It will be work whatever the calibrator's address is.
1～112
2400
4800
9600
8
2
Communication
Address
Baud rate
Data length
Stop bit
Parity bit
Flow control
N/A N/A
39
To Next Page
Loading...
