ADE M118000 - Page 24

Seite 24 von 112 M118000+M118000-01-210305-Rev002-UM-en
- Make sure that the mains cable is routed between the scale and the mains connection in such a
way that there is no risk of stumbling.
- Make sure that the mains cable is routed between the scale and the mains connection in such a
way that there is no risk of strangulation.
- Never push the scale back and forth without lifting, as this may cause damage to the load cells.
- Operate the device only within the permissible ambient conditions.
- After starting up the scale (connecting to the power supply or inserting the batteries), the scale
must warm up for 15 minutes. Accuracy is only guaranteed after this time.
- Do not expose the scale to high temperatures, whether from neighbouring devices or direct
sunlight.
- Use the scale at constant ambient temperatures and avoid using in draughts, otherwise the
measurement results could be falsified.
- After storage under extreme conditions, allow at least 60 minutes for the scale to become
acclimatised and ready for use as directed.
- If possible, place the scale away from other devices or sources that generate electromagnetic
or other disturbances as these can falsify the measurement results.
- Use only approved accessories and peripherals.
- Before cleaning the device, disconnect the mains adapter from the mains.
- Do not immerse the device in water or other liquids.
- If the scale will not be used for a long time, it should be cleaned and stored in a protective film.
The addition of a drying agent is desirable.
- Remove the batteries if you are not going to use the scale for a long time.
- If you have any problems with this device, such as problems with setup, maintenance or use,
please contact your authorised dealer. Do not open or repair the device yourself.
- Please notify the authorised dealer if unexpected operations or events occur.
DO NOT use the scale:
- If the mains adapter is damaged;
- If the battery compartment has an unnatural bulge;
- After long storage in a humid environment.
In such cases, please contact an authorised customer support.