Suggestions for location
DANGER of severe injuries
− During wall installation, there
must be no electrical cables, gas or
water pipes installed in the walls
at the mounting site. Otherwise,
when drilling holes, there is a risk
of electric shock!
The device has a fold-out foot and a hanging
loop for wall mounting.
Where possible, select a location in which the
device is not exposed to direct sunlight.
Setting date and time
If there is more than approx. 10
seconds between two pushes
of a button, the setting process
automatically ends and you will have
to repeat it.
1. Press and hold down MODE until the hour
digit flashes on the display.
2. Use UP or DOWN to set the current hour.
3. Press MODE.
4. Use UP or DOWN to set the current minute.
To Next Page
Loading...
