,-
?.
ma~ (off/timer)
Mta:
This
below the 1RG2RG stitch. It may not
stitch is located
be labelled on all
directly
mite .
Use this swit& in ita ri~t (COM) pogition when a oomputer is
used.
This stitch is used to tell the No. 685 that a com~ter has ben
connected to it.
The No. 685 uses this information to decide
whether or not to switti to the MANUAL mode in the event of a
cmputer failure.
If the nMANUAL Mode on Cmputer Failurew option has been selected
and if the OFF-~M stitch is in the right hand position, the
No. 685 will switch to t~ MANUAL mode in the event of a comwter
faflure.
If a printer is present, the No. 685 may be restored to the AUTO
Mode by moving the OFF-~M dipswitch to the OFF (left)
POSitiOn.
c.
Adtiti~ Stitches (Inside Fli~DWn Panel): T* foilwi ng switches
are ~so to be fomd inside the fli~down panel on the frent of the
unit.
1.
2.
3.
4.
5.
6.
7.
~~nER _ER Selector Stit&: This switti is used to identify
the receiver nmber on message displays and printouts. It may ba
set to my di@t frem 1 to 9 (1 for the first receiver, 2 for a
second receiver, if used, etc.).
== -ST *t&: This switti is used in case of a tsm~rsry
malfmction.
When this stitch is pulled down and released ,
the following events occur:
a.
All m~sa~ memori~ are cleared.
b.
The system is re-initi~i~d.
c.
The stored date end time is &ecked for validity ~d reset
to 12:00 M m Jeu. 1 if so error is detected. The seconds
are ~wa~ reset
to zro.
d. A SYSTEM RzSET m~saga will & displayed and printed (see
Section N E 2 a).
SSWD msoFF Stita: This switch is wed for factory testing
and does not fmction in nom~ operation.
~L DAWm Mt&: This stitch is used only for factory
tasting.
DA= SRT/O~fl~ SST Stit~
-mom wtd
DAY~ Stit&:
These switches are used when setting the internal clock and
ctiendar.
13
www.PDF-Zoo.com
To Next Page
