EasyManua.ls Logo

ADEMCO 685 - MEMORY CARD SETUP PROCEDURE; Memory Card Setup Procedure

ADEMCO 685
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
g)
h)
~ TRANS~SSION ERROR m~sa~ i9 uef~ in conjunction
tith a cmputer.
Since the cmputer is otiy sent
nlid maasa~s, in certain asas, a bad transmission
may not conttin the proper number of chsratiers and may
never et s.nt to the eom~t er.
The TRANS~SSION ERROs
message is fomatted to reach the caput er to advise
the operator to check the reeeiver/printer.
Tm/DA~ ~s?: Wnever the time and/or date ig S*, a m~ga~
is sent to the pfinter and the omputar.
,
Example:
12:00 AM 01/01 10 R~B 5555 5515 7 (V) TI~/DA= RSSET
SYSTSH TEST:
Thig measa~ is ~nerated whenever the SYs~M TRST
Button is pressed as descrikd in Section III A 5.
12:00 AM 01/01 10 R~B 5555 5555 9 (V) SYSTSM ~ST
3.
L= Group Meas~s (T&ephone Line Fatit/R~tme):
Whenever a telephone line fatit or restore occurs , the following
mevsa~ format till appear on the display and (if present) printer and
Cmput ar.
A= 5 for NORML
1 for NEW L~E FAULT
3 for LINE RSSTORR
P
6 for PREVIOUSLY REPORTED
LINE FAULT
Exampl~:
20 L~E 5155 5555 7
(receiver No. 2, line 2 has a fatit)
20 L~E 5355 6555 7
(receiver No. 2, line 2 has restored,
preciously reported line fatit on line 5)
v.
=RY CA~ SSTUP PRO~URS
In order to interface propsrly with any ~rimer~ detices mnneeted to the _
reeei=r (printers, com~tar ), the plastic jmpar plue on the mmory card must
b properly positioned.
32
www.PDF-Zoo.com
firealarmresources.com

Related product manuals