In instances where the phone line is intact, but a line fatit is in~~ted
because of vti ation in the t~ephone cmpsny supplied loop current,
the
phone line testing feature can be bypassed by connecting a shorting wire
between two pins on the line card, ~ shmn in Dia@m 5.
F. k-ing the Ltie Cards:
The slot for line card #8 is the rearmcot slot (Jl3 in Diagram 3) .
dwn frcm the rear untfl you locate the slot for line card #1 (J6).
coat
The
tele~one mnnectors in the rear corr~pnd to these line card # slots.
Cut the tie wrap on the ocnnector corres~nting to the slot and connect the
polarised plug to the mnnector on the top ri@t si~ of the board.
Insert the line card in the slot and pwh fitiy down u~ng the pl~tic
tabs until t% hard snaps into the socket and the tabs move u~srd.
CA~I~
TSR ADRMCO LINR ~RM Nm.
685-5, 685-9 AND 685-9AT EACH
RSQUIRE ~W N Wm E~~~ML ~RENT AS OTHER L~ CARDS
IN THE 685 SERIES.
CO~EQUSWfLY , aRTAm R~T~~IONS MUST
BE ~OSED WHEN USMG THESE URDS ~ TRS
No. 685 DIGITAL
RE~~R.
EA~ L~E CARD USED WTH THE -5, -9 OR -9AT DESI@ATION
REQUR~ TM ~~SAL STATION TO LEAVS ONE BLANK L~ ~RD
SL~ ~ THS RS~MER.
~ EFFS~, EA~ OF THRSE ~~ ~RENT
DRA~G ~R~ US= UP 2 LI~ CARD SLO~ IN TSR
RS~~R.
As stated pretio=ly, the No. 685 is desigced for insttilstionin a standard 19ā
rack or for desk top inct~lation=.
The No. 685~ Cabinet is available for desk
top imtdlation.
The follwing applies to either type of inatdlation.
1.
Locate a 24 how, 120V, 60W, 15A souroe of AC ~er for use with the
No. 685. Plug the line cord provided into the proper connector at the
rear of the No. 685 but DO NOT ~NNS~ TO POWSR WT.
H&e: With non-UL Listed 220 volt e~ort models, a 220VAC, 50 Hz
outlet wfil be needed and the receiverts option PROM chip
ahotid be set for 50 Hz during programming (see Section VI
B).
ā Not rele~t to UL Listed fire alarm monitoring.
-.
www.PDF-Zoo.com
To Next Page
Loading...
