.,-
TABLE E CHANNEL STATUS CODES (HIGH SPEED FORMA~
r the ei@t event mportins ~~s (di~ts 5 through 12), the channel
a~tuscodes are as foll
OWS:
mde Meting
1t
NEW
EVE~ (previously unre~rted ).
2 NEW OPEN~G (previouslyunreported).
3
NKW RESTORE (previously unre~rt ed).
4 NEW CLOS~G (previouslyunre~rted).
5
NOR~L (no event since previously rewrt ed RESTORE).
6
PREVIOUSLY REPORTED RVEM ST~L ~ EFFK~.
o* NRW TROUBR (otiy displayed for e~snded re~rting lW speed
comuni eators).
r th ti~h ~d (di~t 13), the follwing channel status codes are used:
-,
1 DURESS RRPORT in preview 8 channels (specificallychannel 1).
2
OPEN~G REPORT in the previous 8 ohannels (with wer ID in &annel 1
if e~anded reporting of user # is selected at the communicator).
3
ZONE BYPASS STATUS REPORT in the previous 8 channels.
4
&~~G REPORT in the previous 8 channels (with user ID in &annel 1
if e~snded reporting of user # is selected at the communicator).
5
ZONE TROUBLE STATUS ~ ORT in the previous 8 channels.
6
SYSTEM TROUBLE RSPORTS in the previow 8 channels.
~
CHANNEL 1: AC LOSS
CSANNBL 2:
LOW BATTERY
CHANNEL 3: SYSTEM FA~URE
~NNKL 4: WAT~~G TI~R RRSET (LONG RANGR RADIO)
CHANNEL 5:
FA~URE TO RE~ME STATUS MESSAGE (LONG RANGE RADIO)
CHANNEL 6: TEL~ L~E FAULT
~ANNKL 7: NOT USED
~ANNEL 8:
WALK TEST (SENSOR TEST ~DE)
7
ZONE ALAW STATUS REPORT - &arms are remrted in previous 8 channels.
8
~W LOW BATTERY (will mt re-report on subse~ent calls and will mt
send restore) - old him speed format method for reprting system
low battery - ~arm statw is re~rted in the pretious 8 channels.
9
TSST MPORT -
~- status is re~rted in the previous 8 channels.
o RADIO DIAGNOSTIC** – Radio testing infc is re~rted in previous 8
channels (This message will not be sent to the emptier output).
L
+ This code not ued with Radionics B~K software to rewrt Telco channel
problems (code O ued) .
* This code not used for Long Range Radio reporting (code 1 used).
**
Refer to Appendix in this manual (see Ind=) for further information.
..-
19
www.PDF-Zoo.com
To Next Page
