ADEMCO 685 - Page 36

c.
d.
e.
f.
g.
h.
j.
k.
1.
message, must be programed to
closing, a ~OSING (03) message
5.
correspond to code 8.
If code 5
must be selected to correspondto
is a
code
For LW SPRRD fo-t, a RZSTO~ (04) message shodd be Droz~ed for
..-
those dam codes thct indicate restoring of qecif ic a2a=. For
sample, if code 2 is FIRE ALA~ and
code ? restores code 2 and if
code 3 is BURGLAR ALN and code 8 restores code 3. then bOth cOde 7
and code 8 must be assigned a RESTORE (04) message.
The word RESTORE
will print if either code 7 or code a is received,without identifying
in English which condition.restOred.
For HIGH SPEZD fomt, the word RZSTORZ is aut-tidly added to
the corresponding dam message when a restore message is received.
For =aple, if ch=nel 2 is designated as a FIRE ALAW (11) message
channel, a restore status code received on cha~el 2 results in the
message FIRE RESTORE.
A @ssL (05) message is quiv~=t to abort.
FOr LW SPZZO fo=t, da= c~e 9 must be Pr@~~ fOr ~~ish
language if = output is desird.
Messages 01 through 09 may be
~~ed, but the initi~ !ro~tdigits are not used during programing
(for other alarm codes,
the ‘O” digits are retained during
progrming).
For HIGH SPE~ fo-at. English language and display li@t for
Cbsmd 9 ~m B~ -d ~~) are aut~tic.
No progr-ing of
ch=nel 9 is required.
For ~anded reports (Op~, ~OSE, Byp~S,
TROUBLE and SYsTm) charnels 1-8 shOuld be prOgr~ed.
Ud ess “Zone ~
~GLI SH” is used, no further progr-ing is r~uird.
~en a SZSmA fo-t line card (No. 685-3) is OS~S ‘a r~eiv~ c~e
‘Om autmtica21y produces L~ B~Y at the printer -d lights the
LOW BATT. display light
on the No. 685. No English language
programing is neces=~ in this case.
~SSage =Wers 23 ad 24 are for apecia2 applicatiaa -d ale
a display light to be =ed for _I- ALARNe.
As there is no such
desig=ted display light on the No.
685, if message 23 is progr~ed
a -ICAL ALA~” label shodd be -de to cover the WOLD-UP” display
light desig~tion.
If a HOLD-UP output is required as well, use
message 24 and make a
“HOLD-UP” 1abel to cover the BURG. MAHM
desigmtion abme that display light.
In this case, do not also
progr= any burgla~-rdated message (12, 14, 20* 21 Or 22)=
*Not rel-ant to ~ a64 listed fire dam monitoring.
If ~
~eSSage ~der beyond W27= is @dvefimfiy prog-ad, ~OORUP
ERROR NNn will be printed, where NN is the message nmber.
&ssage nbers 81-89 ~ be w~ to p-t ZW N ~ -d ZONZ N
w~ss (N = 1-9) for non-st~darsized channelso
Progrm 81 for Zone
1,
82 for Zone 2, etc.
--
36
www.PDF-Zoo.com
firealarmresources.com