EasyManua.ls Logo

ADEMCO 685 - Page 56

ADEMCO 685
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
freeingthe o~rator from the task of silencingthe No. 685.
ti the
event of a cmputer faflureor a switchto the ~UAL mo&, the alert
tone will ~ triggeredfor al messages.
NOTS: If the ‘PulseRelayn option (SeeSectionVI B 8) has been
chosen,the rmote ~ert relay will activatefor 2 seconds
on ALL messages. This will ~low a remote~ert sounderto
be used at the computerconsolewhfle reservingthe intern~
alertsoonderfor systemmessagesofiy.
6.
Selection of ~~sr out~ f-s for &2 ness~:
When a b-2
message is received,the computeroutput will normallybe in 4-2,
which is:
RG AC~ EI
where R is Receivernumber
G is the line card Groupor rotarynumber
AC~ is the Accountnmbsr
E is an Eventcode
I is the Zoneidentifier
In order to interfaceto the AdemcoCAPS commter system,an optional
outputformat,CAPS4-2,is reqti”red.It is:
RG AC~ DDDA
-
where
DDD is a 3-digitdecim~ numkr in the range O-255
A is an ASCII‘Aw character
me valueof DDD is calctiatedas follows:
DDD = (16 x Eventcode)+ Zone identifier
For Hex event males,the follwing nombrs sre used:
B=ll, c=12, D=13, E= 14, F=15
~smple: InWt Message= 12 3456 F4
DDD = 16x 15 (F) = 240 4 =244
The m-sa~
12 3456244A wodd b sent.
To select the CAPS output fomat, check tox 7 in PROM CRART 7 and
follw the programmingprocedurein SectionVI C steps34 --37.
In addition,the standardcodesfor openingand &osing by user (BO-
BF ad CO
- W respectively)must be translatedto AdemcoHI speedfor
the CAPS system. Whenevera 4-2 code be~nning withB is received,an
opening remrt is sent.
The user # will be set to matti the mne
identifierof the message.
-
Users are encouragedto use codesB and C for openand close. For
56
www.PDF-Zoo.com
firealarmresources.com

Related product manuals