Loss of AC power and use of backup battery power is indicated by NO AC. or AC LOSS.
A low battery condition is indicated by BAT or SYSTEM LO BAT
For instructions on replacing your battery, please visit our Battery Replacement Page.
Bypassing Protected Areas
Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to
access a protected area when the system is armed.
To bypass a zone, enter your [security code] + [BYPASS] + [2 digit zone number].
To unbypass a zone, disarm the system.
Change Time and Date
To change date and time settings, enter your [security code] + [#] + [6] + [3].
Wait until time/date are displayed, then press [*] to move the cursor ahead and [#] to move back.
Enter the 2-digit hour and minute settings, i.e., [06] and [17] for 6:17.
Press [1] for PM or [2] for AM.
Continue to enter 2-digit year, month, and day settings, i.e., [15], [08], and [23] for August 23, 2015.
To exit, press [*] when the cursor is on the last digit.
Chimes and Beeps
When your system is in chime mode, a chime alert will sound three tones whenever a protected door/window
is opened.
To turn chime mode on and off, enter your [security code] + [CHIME].
Reset
To clear the display after an alarm event, enter your [security code] + [OFF] sequence twice to clear the alarm
event history.
Security Codes
Your system allows for additional users, however only the Master user can assign user codes to users.
To Next Page
Loading...
