ADEO Services WAP-357EM - Troubleshooting

Does not run
Stops running during
operation
Runs but does not cool
Do not run and water
full indicator lights
Troubleshooting
The following cases may not always be a malfunction, please check it before asking for service.
‘If the protector trip or fuse is blown, please
wait for.
*Please wait for 3 minutes and start again,
protector device may be preventing unit
from working.
*Ifbatteries in the remote control are used
Up.
+ If the plug is not properly plugged.
-If the set temperature is close to room
temperature, you can lower the set
temperature.
*Air outlet be blocked by obstacle.
Take the obstacle away.
-If the door or window open.
-If there is other heater appliance work
nearby, like heater or lamp, etc...
“The air filter is dirty, please clean it.
-Air outlet or intake be blocked.
*Set temperature is too high.
‘Drain the water into a prepared container
by the drainage pipe on the rear panel of
the unit. Ifit still doesn't work, please
consult a qualified technician.