ADI AR-146 - MEMORY CHANNELS AND ENTRY; Memory Channel Functions; Entering Memory Data

5-4-4 Memory Channel
This transceiver provides 40 Memory Channels.
In addition to serving as a normal Memory Channel some of the
Memory Channeis serve a dual purpose to specify other parameters.
The functions of those Memory Channels are described below.
© Memory Channel 1 is used to stroe the frequency for the DUAL-
WATCH function.
© Memory Channel 11 is used to store the lower limit for the
Programmab!e Band Scan function.
© Memory Channel 12 is used to store the upper limit for the
Programmable Band Scan function.
5-4-5 Memory Entry
® Simplex/Normal shift
1.
Press
the
VFO/M
P&
V
key
to
select
the
VFO
mode.
2.
Select
the
desired
operating
frequency,
offset,
tone
frequency,
etc.
(
For
example
145.500MHz
?}
3. Press the F key. The F indicator and a memory channel indicator
will light. € For example CH8 )
. Select the desired Memory Channel using the Tuning Control or
microphone UP/DN switches. (For example CH5 )
_ Press the MR/M Kay within 10 seconds of selecting the Memory
Channel. A long beep will sound and the F indicator and the
Memory Channel number will turn on and the transcetver will
change into the Memory mode.
18