ADI AR-446 - Code Lockout; DTMF Code Decoding Function; Setting the CODE Decoding Mode

3. When called with your station ID code, the memory number
automatically change to G. The ID code of the member 3 is
displayed.
Flashing local statian code
pal YYY |
4. The squelch is opened.
5. The individual code of the calling station is stored in memory 0.
Press
the
PTT
switch
to
respond
to
the
calling
station.
145.660MHz
444% 111
-- ae
= 4 S668
LH
BUSY
OMOSUBOCmZOeMOUL
™
When the transmission ends, the frequency wil! be displayed again.
After the local station has been contacted, cancel paging mode.
Communicatin can be performed more efficiently.
If the local station code can not be decorded, “ Err” appears on the
display.
| Stand by with group code
1.
( |
meonbe er |
Mee _,
Flashing
When a call is received with the group code, the squelches of all
the members of the group are opened to enable reception.
When you are called with the group code, the common group
code and its memory channel number are displayed.
(Exapmple:Group code 789 is stored in channel 3.)
Group code
3 is displayed to indicate that the
station is being called.
. When the PTT switch is pressed, group code 789 (as displayed)
and your station 1D code are transmitted. You can participate in
the group-roundtable.
. After the remote station has been called, cancel paging mode.
Communication can be performed more efficiently.
5-10-5 Co
(A code is
function.)
If an individu
when the coc
another. To u
memories.
When you ar
same frequer
temporarily sl
® Paging n
1. Enter the
memory 0
2. Press the
SKP mark
a
3. To cancel,
5-11 DT
The DTMF |
optional DTA
The Decodir
signal on the