ADI AR-446 - BEEP; LOCK; Microphone Key Lock

5. Or you can press the MHz/LOCK or the microphone MHz key to
clear the content of DTMF codes.
Call YEO MR pcg
OOO
3. To leave the automatic power-off state, turn the power switch off
6. Press VFO/MbV or MR/M key to return to and on again.
the normal frequency mode.
Notes
5-11-2 Store the CODE Memory A small current flows during the automatic power off state. If the
transceiver is not going to be used, be sure to switch the power
You can keep the decaded code data even when you power-on next
. . off.
time if necessary.
The procedure is:
5-13 DIM(DIMMER
Press MR/M key to store the code data and a long PI- sound will be ( )
generated.
The
intensity
of
dial
illunimation
can
be
set
to
one
of
four
levels.
1. Press the F key, then press the LOW/DIM key while the F
indicator lights.
5-12 APO(Automatic Power Off)
The automatic power-off function turns the power off automatically ff 2
you forget. (— i
The initial setting is OFF. | l d . 2 l
1. To turn the APO function off and on, press the F key for longer ' ‘
than 1 second, then MH2z/LOCK key within 10 secands. The APO \_™ J
indicator lights, I
2. (f, after 30 minutes in inactive receive mode, no key has been 2. Select the desired value with the tuning control or the UP/DN key
pressed, the APO indicator flashes and a beep sounds. After that on the microphone.
all the functions are disabled, and the transceiver enters the 3. If, after 10 seconds, no key has been pressed, the displayed level is
automatic power-off state. set and the original frequency is redisplayed.
35
5-14 BE
The beep car
Press the F |
while the F i
Each time th
VFO MR MF
MY M Lot
SS
5-15 LO
There are tw
@MMicrophe
When the
position, a