Zound Industries International AB
adidas
RPT-02 SOL
Zound Industries International AB / China
Refer to the date code sticker on the bottom of the packaging
R-C-Dte-
RPT02SOL
© All rights reserved. adidas, the Badge of Sport and the
3-Stripes mark are registered trademarks of adidas used
by Zound Industries International AB under license from
adidas AG.
© Tous droits réservés. adidas, le “Badge of Sport” et le
logo de marque à 3 bandes sont des marques déposées par
adidas et utilisées par Zound Industries International AB sous
licence d’utilisation accordée par adidas AG.
Design of the device is intellectual property of Zound
Industries International AB.
The Bluetooth
®
wordmark and logos are registered
trademarks owned by the Bluetooth SIG, Inc. and any use of
such marks by Zound Industries is under license.
The Powerfoyle™ wordmark and logo are registered
trademarks of Exeger Operations AB.
Google Play is a trademark of Google LLC.
Apple and the Apple logo are trademarks of Apple Inc.
registered in the U.S. and other countries. App Store is a
service mark of Apple Inc., registered in the U.S. and other
countries.
All other trademarks are the property of their respective
owners and may not be used without permission.
Zound Industries International AB, Centralplan 15, 111 20
Stockholm, Sweden
FCC statement
FCC ID is located under the left ear cushion. To remove, hold
ear cushion and turn counter-clockwise.
WARNING: Any changes or modications to this device not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation. This equipment
complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This device must not be
co-located or operating in conjunction with any other antenna
or transmitter.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
U.S. responsible party, contact information:
Zound Industries USA, Inc.
260 W 39th Street Suite 1101, New York, NY 10018, USA
Telephone number: 646-214-1003
LEGAL NOTICE
IC statement
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme à la norme RSS sans licence
d’Industrie Canada. Son fonctionnement est soumis aux
deux conditions suivantes : (1) cet appareil ne doit pas
provoquer d’interférence et (2) cet appareil doit supporter les
interférences, y compris les interférences susceptibles de
provoquer un fonctionnement inattendu.
This device complies with the RF exposure limits for an
uncontrolled environment set forth by Industry Canada.
Canadian information on RF exposure and compliance can be
obtained from Industry Canada.
Cet appareil est conforme aux réglementations d’Industrie
Canada concernant les limites d’expositions aux
radiofréquences dans un environnement non contrôlé. Les
informations sur l’exposition aux RF et de conformité pour le
Canada peuvent être obtenues auprès d’Industrie Canada.
This Class B digital device complies with Canadian ICES-003.
Cet appareil numérique de classe B est conforme à la norme
ICES-003 au Canada.
CAN ICES-003 (B)/NMB-003(B)
Ifetel
La operación de este equipo está sujeta a las siguientes dos
condiciones: (1) es posible que este equipo o dispositivo no
cause interferencia perjudicial y (2) este equipo o dispositivo
debe aceptar cualquier interferencia, incluyendo la que pueda
causar su operación no deseada.
Anatel
Este produto está homologado pela ANATEL, de acordo
com os procedimentos regulamentados pela Resolução n°.
242/2000 e atende aos requisitos técnicos aplicados. Este
equipamento não tem direito à proteção contra interferência
prejudicial e não pode causar interferência em sistemas
devidamente autorizados.
Para maiores informações, consulte o site da ANATEL –
www.anatel.gov.br
R0.2
Complies with
IMDA Standards
DA106056
To Next Page
Loading...
Need help?
General
