ADJ Products, LLC • Los Angeles, Ca USA • Kerkrade, Netherlands
INSTALLATION
DO NOT INSTALL THE PANEL IF YOU ARE NOT QUALIFIED TO DO SO!
INSTALLATION BY QUALIFIED TECHNICIANS ONLY!
INSTALLATIONS SHOULD BE CHECKED BY A QUALIFIED PERSON ONCE A YEAR!
FLAMMABLE MATERIAL WARNING
Keep panel minimum 5.0 feet (1.5m) away from flammable materials and/or pyrotechnics.
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
A MAXIMUM OF 24 panels may be suspended from each other vertically in a curtain.
An unlimited number of panels may be installed horizontally.
(NOTE: Additional processing may be necessary)
USE CAUTION WHEN POWER LINKING MULTIPLE PANELS AS THE POWER CONSUMPTION
OF OTHER PANEL MODELS MAY EXCEED THE MAX POWER OUTPUT ON THIS PANEL.
CHECK SILK SCREEN FOR MAX AMPS.
MAXIMUM POWER
CONSUMPTION (W)
WARNING! The safety and suitability of any lifting equipment, installation location/platform,
anchoring/rigging/mounting method and hardware, and electrical installation is the sole responsibility of
the installer.
Panel(s) and all panel accessories and all anchoring/rigging/mounting hardware MUST be installed
following all local, national, and country commercial electrical and construction codes and regulations.
Before rigging/mounting a single panel or multiple interconnected panels to any metal truss/structure, a
professional equipment installer MUST be consulted to determine if the metal truss/structure or surface is
properly certified to safely hold the combined weight of the panels(s), clamps, cables, and all accessories.
Inspect metal truss/structure visually to ensure it does not flex and/or become deformed due to the weight
of the panel(s). Damage caused to panel(s) by mechanical stress is not covered by warranty.
Panel(s) should be installed in areas outside walking paths, seating areas, or away from areas were
unauthorized personnel might reach the panel(s) by hand. Access under work area must be blocked.
NEVER stand directly below the panel(s) when rigging, removing or servicing.
OVERHEAD RIGGING
Overhead fixture installation must always be secured with a secondary safety attachment, such as an
appropriately rated safety cable. Overhead rigging requires extensive experience, including amongst
others calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the fixture. If you lack these qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injury and property damage.
To Next Page
Loading...
General