ADJ ELEMENT HEX - Page 21

OPERATING INSTRUCTIONS
21
RGBWA & UV Dimmer Mode:
1. Plug the xture in and press the MODE button “r: XXX” is displayed. You now are in Red dimming
mode. Press the UP and DOWN buttons to adjust intensity. After you have nished adjusting the
intensity, or if you would like to skip to the next color, press the SET UP button.
2. When “G: XXX” is displayed you are in Green dimming mode. Press the UP and DOWN buttons to
adjust the intensity.
3. When “b: XXX” is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust the intensity.
4. When “U: XXX” is displayed you are in White dimming mode. Press the UP and DOWN buttons to
adjust the intensity.
5. When “A: XXX” (Amber) is displayed you are in Amber dimming mode. Press the UP and DOWN
buttons to the adjust intensity.
6. When “u: XXX” is displayed you are in UV dimming mode. Press the UP and DOWN buttons to
adjust the intensity.
7. After you have adjusted the colors to make your desired color, you can then activate strobing by
pressing the SET UP button to enter the strobe mode.
8. “FS: XX” will be displayed, this is strobe mode. The strobe can be adjusted between “00” (ash
o) to “15” (fastest ash).
Sound Active Mode:
1. To Plug the xture in and press the MODE button until “SoXX” is displayed. “XX” represents the
current sound active mode (1-16).
2. Use the UP or DOWN buttons to nd your desired sound active mode.
3. Press the SET UP button to enter sound sensitivity adjustment. “SJ-X” will be displayed. Use the
UP or DOWN buttons to adjust the sensitivity. “SJ-1” is the lowest sensitivity, “SJ-8” is the highest.
“SJ-0” turns the sound sensitivity o.
Static Color Mode (Color Macros):
1. Plug the xture in and press the MODE button until “CLXX” is displayed.
2. There are 63 colors to choose from. Select your desired color by pressing the UP and DOWN
buttons. After you have selected your desired color you can activate strobing by pressing the SET
UP button to enter the Flash (strobe) mode.
3. “FS.XX” will be displayed, this is Flash mode. The Flash can be adjusted between “FS.00” (ash
o) to “FS.15” (fastest ash).
Auto Run Mode:
There are 3 types of Auto Run Modes to choose from; Color Fade, Color Change, and both color
change and color fade modes running together. The running speed is adjustable in all 3 modes.
1. Plug the xture in and press the MODE button until either “AFXX”, “AJXX”, or “A-JF” is displayed.
• AFXX - Color Fade mode, there are 16 Color Fade modes to choose from. Use the UP or
DOWN buttons to scroll through the dierent Auto Fade modes.
• AJXX - Color Change mode, there are 16 Color Change modes to choose from. Use the UP or
DOWN buttons to scroll through the dierent Auto Change modes.
• A-JF - Both Color Fade and Color Change modes running.
2. After you have chosen your desired running mode press the SET UP button until “SP.XX” is
displayed. When this is displayed you can adjust the running speed of your desired program. Use
the UP or DOWN button to adjust the speed between “SP.01” (slowest) and “SP.16” (fastest). Once
you have set your desired running speed, press the SET UP button to return to your selected Auto
Run mode.