ADJ ELEMENT HEX - Page 22

OPERATING INSTRUCTIONS
DMX State:
This mode denes how the xture will operate in the event that the DMX signal is lost or interrupted.
1. Plug the xture in and press the MODE button until “d.XXX” is displayed. “XXX” represents the
current displayed DMX address.
2. Press the SET UP button so that “nodn” is displayed. Use the UP and DOWN buttons to scroll
through the DMX states.
• “bLAC” (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• “LASt” (Last State) - If the DMX signal is lost or interrupted, the xture will stay in the last
DMX set up. If power is applied and this mode is set, the unit will automatically go into the last
DMX set up.
• “ProG” (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into
Auto Run mode.
3. After you have found your desired setting, press SET UP to exit.
WiFly On/O and Wireless Addressing:
This function is used to activate the WiFly control and set the WiFly address.
NOTE: The address must match the address that is set to WiFly TransCeiver or WiFly controller.
1. Plug the xture in and press the MODE button until “rCXX” is displayed. This is the wireless set
up mode.
2. Press the UP or DOWN buttons the UP or DOWN buttons to turn the Wireless “On” or “Of” (O).
3. Press the SET UP button to enter the Wireless address menu. Use the UP or DOWN buttons to
select your desired Wireless address.
Activate IR Sensor:
This function is used to activate and deactivate the IR sensor. When this function is activated you
can control the xture using the UC IR remote or Airstream IR App. Please see page 23 for controls
and functions.
1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either
“on” or “oF” (O).
2. Press the SET UP button until “IrXX” is displayed. “XX” represents either “on” or “oF” (O).
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (O).
Secondary Setting:
This function is used to designate the unit as a “Secondary” unit in a Primary-Secondary set up.
Plug the xture in and press the MODE button until “Secd” is displayed. The unit is now designated
as a “Secondary” unit in a Primary-Secondary set up and will follow the actions of the primary unit.
Default Running Mode:
This is a default running mode. When this mode is activated all modes will return to their default set-
tings.
1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either
“on” or “oF”.
2. Press the SET UP button until “dEFA” is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.
22