23
This function will allow you to link units to run in a Primary-Secondary set-up. In a Primary-Second-
ary set up one unit will act as the controlling unit and the others will react to the controlling units
built-in programs. Any unit can act as a Primary or as a Secondary however, only one unit can be
programmed to act as the “Primary.”
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the output. The rst unit in the chain (primary) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the rst “Secondary” unit to the “Primary.”
3. Set the “Primary” unit to your desired mode of operation. On the “Secondary” unit(s) press the
MODE button until “SEcd” is displayed. Refer to the Operating Instructions section of this man-
ual.
This unit can only be controlled using WiFly. Your DMX controller must be connected to a ADJ WiFl
Transceiver to use this function. You are able to communicate up to 2500 feet/760 meters (open line
of sight).
1. Refer to the steps listed in the Operation Instructions section of this manual to set the WiFly ad-
dress and to activate WiFly. The address must match the address set on the WiFly WiFly Trans-
ceiver.
2. After you have set the WiFly address, follow the DMX instructions shown in the Operation In-
structions section of this manual to select your desired DMX Channel mode and set your DMX
address.
3. The xture must be set up rst before you apply power to WiFly Transceiver.
4. If everything is set up properly and the xture is receiving a Wireless signal, you should now be
able to control it with a DMX controller.
WiFly Primary-Secondary Set Up:
This function will allow you to link units together via WiFly to run in a Primary-Secondary setup.
1. Follow the instructions in the Operation Instructions section of this manual to set the WiFly ad-
dress and to activate WiFly. The addresses on each xture must be the same.
2. After you have set the WiFly address, select your “Primary” unit and set your desired operating
mode.
3. Set the “Primary” unit to your desired mode of operation. On the “Secondary” unit(s) press the
MODE button until “SEcd” is displayed. Refer to the Operation Instructions section of this man-
ual for more detailed information.
4. If everything is set up correctly, the “Secondary” units will start following the “Primary” unit.
PRIMARY-SECONDARY SETUP
WIFLY SETUP
WIFLY PRIMARY-SECONDARY SETUP
To Next Page
Loading...
