What to do if ADJ DJ Equipment is not responding to DMX?
If your ADJ DJ Equipment isn't responding to DMX, make sure the DMX cables are properly connected and correctly wired. Specifically, check that pin 3 is the 'hot' pin (note that on some devices, pin 2 might be 'hot'). Verify that all cables are connected to the correct input and output connectors, as the connection direction matters.
Key warnings regarding electrical safety, fire, and proper use.
Instructions for safely mounting the fixture and ensuring stability.
Precautions to prevent electrical shock and fire hazards.
Guidelines for indoor use, ventilation, stable mounting, and cord safety.
Advice on cleaning and when professional service is required.
Overview of Dimmer, Fade, and DMX control modes.
Steps to set DMX address and choose the channel mode for controller use.
Selecting different dimming curve profiles for DMX operation.
Configuring the fixture's response when DMX communication is interrupted.
Instructions for linking units to operate in a synchronized primary-secondary setup.
Details on the functions of various buttons on the RC2 remote.
Using the RC2 remote to set DMX address, channel mode, and dimmer curve.
Solutions for problems like the unit not responding to DMX.
Detailed explanation of the warranty coverage, limitations, and exclusions.
Comprehensive list of technical specifications for the Encore Profile 1000 WW.
Key warnings regarding electrical safety, fire, and proper use.
Instructions for safely mounting the fixture and ensuring stability.
Precautions to prevent electrical shock and fire hazards.
Guidelines for indoor use, ventilation, stable mounting, and cord safety.
Advice on cleaning and when professional service is required.
Overview of Dimmer, Fade, and DMX control modes.
Steps to set DMX address and choose the channel mode for controller use.
Selecting different dimming curve profiles for DMX operation.
Configuring the fixture's response when DMX communication is interrupted.
Instructions for linking units to operate in a synchronized primary-secondary setup.
Details on the functions of various buttons on the RC2 remote.
Using the RC2 remote to set DMX address, channel mode, and dimmer curve.
Solutions for problems like the unit not responding to DMX.
Detailed explanation of the warranty coverage, limitations, and exclusions.
Comprehensive list of technical specifications for the Encore Profile 1000 WW.
Electrical Specifications| voltage | 100V ~ 240V/50~60Hz |
|---|---|
| power draw | 144W |
| fuse | 3 Amp |
Lighting Specifications| LEDs | 1 x 120W WW COB LED (3200K, CRI 98) |
|---|---|
| beam angle | 12-30 Degrees |
| colors | Warm White |
Dimensions and Weight| weight | 19 lbs./ 8.5Kgs |
|---|---|
| dimensions | 22” (L) x 9.75” (W) x 15.25” (H) 560 x 250 x 385mm |
To Next Page
