Do you have a question about the ADJ Mega GO Bar 50 RGBA and is the answer not in the manual?
Check shipping carton for damage and missing accessories upon arrival.
Details the rechargeable, DMX intelligent LED bar fixture and its modes.
Provides contact information and operating hours for assistance.
Guidelines on preventing short circuits, mechanical shock, and proper connection.
Details on internal insulation layers and preventing short circuits.
Warnings against disassembling batteries due to harmful fumes or fire risk.
Details the automatic voltage switch for universal power compatibility.
Explains DMX protocol, linking, and addressing for intelligent control.
Specifies 3-pin XLR connectors and cable requirements for DMX operation.
Guidance on using terminators to prevent signal errors in long DMX runs.
Explains options for powering the unit via AC power or battery.
Instructions for turning the LED display on/off and inverting it.
Overview of the five operating modes: Sound-Active, Static Color, Auto Run, RGBA, DMX.
Guide to controlling the fixture via DMX controller and selecting DMX modes.
Steps for linking units in Master-Slave mode using XLR connections.
Details on using the ADJ RFC remote for blackout, auto run, and program selection.
Check DMX cable connections and wiring for proper DMX communication.
Ensure sound is not too quiet and Sound Active mode is activated.
Details terms, conditions, and limitations of the product warranty.
Check shipping carton for damage and missing accessories upon arrival.
Details the rechargeable, DMX intelligent LED bar fixture and its modes.
Provides contact information and operating hours for assistance.
Guidelines on preventing short circuits, mechanical shock, and proper connection.
Details on internal insulation layers and preventing short circuits.
Warnings against disassembling batteries due to harmful fumes or fire risk.
Details the automatic voltage switch for universal power compatibility.
Explains DMX protocol, linking, and addressing for intelligent control.
Specifies 3-pin XLR connectors and cable requirements for DMX operation.
Guidance on using terminators to prevent signal errors in long DMX runs.
Explains options for powering the unit via AC power or battery.
Instructions for turning the LED display on/off and inverting it.
Overview of the five operating modes: Sound-Active, Static Color, Auto Run, RGBA, DMX.
Guide to controlling the fixture via DMX controller and selecting DMX modes.
Steps for linking units in Master-Slave mode using XLR connections.
Details on using the ADJ RFC remote for blackout, auto run, and program selection.
Check DMX cable connections and wiring for proper DMX communication.
Ensure sound is not too quiet and Sound Active mode is activated.
Details terms, conditions, and limitations of the product warranty.
| voltage | 100V ~ 240V/50~60Hz |
|---|---|
| power draw | 25W |
| fuse | 2 Amp |
| battery life | 8 Hours Full On (Full Charge) |
|---|---|
| battery lifetime | 500 Charges |
| battery type | Auto Sensing Voltage |
| weight | 5lbs./ 2.2Kgs. |
|---|---|
| length | 24.75” / 625mm |
| width | 2.75” / 65mm |
| height | 3.5” / 88mm |
Loading...