ADJ MEGA HEX PAR - Dimmer Curve and Default Mode; Master-Slave Configuration; Master-Slave Connections

13
OPERATING INSTRUCTIONS
ADJ Remote Activation: This function is used to activate or deactivate the IR sensor. When this
function is activated, the xture can be controlled using either the ADJ UC IR or Airstream App.
Please see the IR Remote Control section of this manual for detailed information.
1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either “on”
or “oF”.
2. Press the SET UP button until “IrXX” is displayed. “XX” represents either “on” or “oF”.
3. Press the UP or DOWN buttons to either activate (“Iron”) or deactive (“IroF”) the remote function.
DMX State: This mode denes how the xture will behave in the event that the DMX signal is lost or
interrupted, or the mode it will default to when power is rst connected.
1. Plug the xture in and press the MODE button until “d.XXX” is displayed. “XXX” represents the
currently selected DMX address.
2. Press the SET UP button so that “nodn” is displayed. Use the UP and DOWN buttons to scroll
through the DMX states.
• “bLAC” (Blackout) - The unit will automatically go into stand by mode.
• “LASt” (Last State) - The unit will stay in the last DMX set up.
• “ProG” (Auto Run) - The unit will automatically go into Auto Run mode.
• “nAnU” - The unit will automatically go into RGBA+UV dimmer mode.
3. Use the UP and DOWN buttons to nd the desired DMX state, then press SET UP to conrm and
exit.
Dimmer Curve Setting:
1. Plug the xture in and press the MODE button until “d.XXX” is displayed, then press the SET UP
button until “dr-X” is displayed. “X” represents a number between 0-4.
2. There are 5 dimmer curve settings to choose from. Please see the Dimmer Curve Chart section
of this manual for the settings and their respective beginning and ending fade times.
Default Running Mode: This returns all modes to their default settings.
1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either “on”
or “oFF”.
2. Press the SET UP button until “dEFA” is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.