To Next Page
A
Austin AustinAug 1, 2025
What to do if my Adleepower AP2G3-137 Inverter shows PF01 error?
- MMark StewartAug 1, 2025
If your Adleepower Inverter displays the error code PF01, it could be due to several reasons. It may be caused by a power device failure during acceleration, which can be solved by increasing the acceleration time. Alternatively, it might be due to boost voltage being too high, in which case, reduce CD21 contents. Another possibility is that the motor is locked, or the load is too heavy; try reducing the load factor. Finally, disconnect the output wiring U.V.W. Restart (Run) the inverter and check for the same message, if the problem persists, repair the inverter.
General
