Adleepower AP4G3 - User Manual

Questions and Answers

S
scooperAug 14, 2025
What to do if my Adleepower Inverter displays PF01?
- A
  Amanda VegaAug 14, 2025
  If your Adleepower Inverter displays PF01, it indicates a power device failure during acceleration, boost voltage being too high, a locked motor or an excessively heavy load, or a disconnection in the output wiring. You can try increasing the acceleration time, reducing CD21 contents, or reducing the load factor. If the problem persists after checking the output wiring (U.V.W.) and restarting the inverter, consider repair.
B
Brent ChanAug 17, 2025
What does it mean when my Adleepower Inverter shows PF02?
- A
  Angela WardAug 18, 2025
  A PF02 error on your Adleepower Inverter signals a power device failure during constant frequency operation, or that the ambient temperature is too high. To resolve this, eliminate sudden changes in load and reduce the ambient temperature.
M
Mitchell KruegerAug 20, 2025
What to do if my Adleepower Inverter displays PF03?
- J
  Jennifer LittleAug 20, 2025
  If your Adleepower Inverter is showing PF03, it means there's a power device failure during deceleration, or the power supply voltage is too high. You should set the deceleration time suitable for load GD2 and reduce the voltage within the specified range.
M
Melissa MillsAug 25, 2025
What does PF04 mean on my Adleepower Inverter?
- K
  Keith Pugh MDAug 25, 2025
  A PF04 error on your Adleepower Inverter indicates a power device failure during stand-by. You should remove the cause and reduce the voltage.
X
Xavier MurphyAug 27, 2025
What does LOLO mean on my Adleepower Inverter?
- G
  Gina WilliamsAug 28, 2025
  If your Adleepower Inverter displays LOLO, it indicates low voltage. Try increasing the input voltage and reducing the load.
J
Janet JohnsonAug 30, 2025
Why is there no display on my Adleepower Inverter?
- E
  Eddie KnoxAug 31, 2025
  If there is no display on your Adleepower Inverter, the discharge LED is extinguished. Turn on or replace the MCCB.
C
csandersSep 3, 2025
What does UPLO mean on my Adleepower Inverter?
- D
  Debra BrownSep 3, 2025
  If your Adleepower Inverter displays UPLO, it means there is an open U.V.W. Check the output U.V.W. circuit or setting CD93=0.
R
Richard MaldonadoSep 6, 2025
What does LOSE mean on my Adleepower Inverter?
- A
  Andrew RileySep 6, 2025
  If your Adleepower Inverter displays LOSE, it indicates a communication loss or error. Check the communication circuit or communication code.
J
Jessica WangSep 9, 2025
What does EEP1 mean on my Adleepower Inverter?
- J
  John HartSep 9, 2025
  If your Adleepower Inverter displays EEP1, it indicates an EEPROM access error. Consider repair.