Connectors & Jumpers 13
M-322
2 Connectors & Jumpers
The connectors and jumpers on the M-322 allow you to connect
and configure external devices. The following specify the pin
assignments for connectors and jumper on the M-322. Refer to
Figure 1-2: M-322 Board Layout and Figure 1-3: M-322 Rear
I/O Layout for connector and jumper locations.
2.1 Rear I/O Connectors
PS/2 Mouse Port (green)
PS/2 Keyboard Port (purple)
Pin # Signal Function
1MSDATAMouse Data
2 NC not connected
3 GND Ground
4+5V Power
5 CLK Clock
6 NC not connected
Pin # Signal Function
1 KBDATA Keyboard Data
2 NC not connected
3 GND Ground
4+5V Power
5 CLK Clock
6 NC not connected
To Next Page
Loading...
