Lynx & QuickConnect Troubleshooting
https://alpha.adt.com/help/206[11/13/2018 8:20:40 PM]
Lynx & QuickConnect Troubleshooting
Includes the following systems: Ademco Lynx and Safewatch QuickConnect Plus.
« Help Center
Trouble Conditions Trouble Codes Related Topics
Trouble Conditions
Trouble conditions, or trouble codes, are indicated by the word CHECK and continual beeping from the
touchpad. Any key will silence the beeping. A display of CHECK + zone no. may indicate that a problem
requires your attention. Check the specified zone area, close any open doors or windows and enter your
security code and press [OFF]. If your system includes wireless sensors, the CHECK condition may be
caused by some change in the environment of the protected area.
To silence trouble beeps, press any key or enter your [security code] and press [OFF].
Causes of Trouble Codes
Displays Trouble Condition
AC/No AC
The system has lost AC power from the transformer that is plugged into your
building's power. It is continuing to operate for a limited time on the backup
battery. Refer to the Power Failure Troubleshooting
page.
ALARM
Appears when an intrusion alarm goes off while the system is armed, during a
fire alarm or when an audible emergency alarm is sounding. Your panel will
display the protection zone that is in alarm.
To cancel an alarm, press [security code] + [OFF].
AWAY
All burglary zones (e.g. doors, windows, glass breaks, etc.) are armed. This is
an informational message.
bF
This indicates that the cell or radio unit used by the system is not working, or
that the system has lost contact with it. The system is unable to connect with
the Monitoring center. Refer to the Radio Frequency Interference
Troubleshootingpage.
This message is displayed when one or more burglary protection zones have
been bypassed. This is an informational message.
Select
To Next Page
Need help?
General
