SPECIAL FEATURES
The CHIME mode allows audible monitoring of zones while
the
system is
disarmed. When the CHIME mode is active, the control station sounder will beep
whenever a perimeter burglar defined zone (door, window, etc.) indicator is opened.
For example, the CHIME feature will cause the control station to beep two times
whenever the front door has been opened. Many businesses use this type of signal
to announce that a customer has entered. In a residential application, the CHIME
is useful for monitoring opening of doors by children.
0
1.
2.
3.
cl
1.
To Turn CHIME On
The
system must be disarmed.
Press the “6” key and hold for three seconds. The control station will beep three
times to signify that the CHIME has been turned on.
The control station will now beep two times when any burglar zone is
opened.
Note: The CHIME feature does not annunciate
lntertor
zones.
To Turn The CHIME
Off
Press the
“6”
key and hold for three seconds. The control station will beep two
times to signify that the CHIME has been turned off.
Your system may be programmed for quick arming even with one or more zones
faulted. In this condition, when an attempt is made to arm the system with faulted
zones (READY light off), the control station will emit a three second error tone,
indicating that the system refused to arm. If a second attempt to arm is made within
eight seconds after the tone quits, all faulted zones will automatically be bypassed
and the system will Force Arm. Depending upon how your system was
pro
grammed at the time of installation, force armed zones will either be permanently
bypassed until disarming or may return to operation when or if they become
operable.
8
To Next Page
Loading...
Need help?
General
