Programming
Certain features of your system are programmable through the control station. The
programming mode is entered by pressing key 9 and holding for three seconds, then
entering the Master User Code. Other programming functions may be possible that
are not detailed in this section. Consult your security representative for a list of the
user programmable features of your system.
WARNING:
Do
not attempt to program the system unless you have been
properly trained on programming procedures and you are sure that you
fully understand
thlsopwatlon.
USER CODES
Your system may be programmed to accept up to five regular User Codes and one
Muster User Code.
Each code
may be comprised of any four digit sequence. (Do
not program 1234 or 1111 as User Codes). Codes may be added, deleted, or changed
as necessary.
The Master User Code (code 1) performs all of the User Code functions plus allows
access to the programming mode.
User Code 6 may be programmed as a Temporary User Code with a limited number
of valid uses, after which it becomes inoperable.
This code may be assigned to a
maintenance person, maid, or anyone who you would like to be able to arm and
disarm the system for a selected number of times without having to reveal your
regular code.
A
To Next Page
Loading...
Need help?
General
