Safewatch Pro 3000 Quick Guide
https://alpha.adt.com/help/10.html[11/6/2018 2:33:15 PM]
Your system allows up to 45 different security codes for use by other users, however only the Master user
or Partition Programmer can assign user codes to users. Users are also assigned an Authority Level,
which defines the functions a particular user can and cannot perform.
To add a user code, enter your [Master/Partition Programmer code] + [8] + [user number] + [new
user’s code].
To delete a user code, enter your [Master/Part. Prog code] + [8] + [user number] + [#] + [0].
To assign an authority level, enter your [Master/Part. Prog code] + [8] + [user number] + [#] + [1] +
[authority level].
Some user authority levels have been pre-programmed:
User
Authority
Level
Explanation Code to assign to user
Master Can perform all functions and assign codes.
[Master code] + [8] + [0] +
[2] + [new master code] +
[new master code]
Standard Can only perform security function in assigned partitions. [0]
Arm Only Can only arm the system. [1]
Guest
Can arm the system in assigned partitions, but cannot disarm
the system unless the system was armed with this code.
Perfect for babysitters, cleaners, etc.
[2]
Duress
Intended for use for when you are forced to arm or disarm
the system against your will.
[3]
Partition
Programmer
Can do everything a Standard user can do plus assigning
user codes to partitions.
[4]
For a complete list of use authority levels and partitions, please see the Safewatch Pro 3000 system
manual.
Trouble Conditions
Trouble conditions are indicated by the word CHECK and continual beeping from the touchpad. Any key
will silence the beeping. A display of CHECK + zone no. may indicate that a problem requires your
attention. Check the specified zone area, close any open doors or windows and enter your security code
and press [OFF]. If your system includes wireless sensors, the CHECK condition may be caused by some
change in the environment of the protected area.
To Next Page
Loading...
Need help?
General
