SDI Ancillary data and OSD overlay have unique configuration for each SDI bank
Connector: Four BNC (75 Ohm) - Two per bank
CVBS
SD NTSC or PAL D1 Composite Video Output (downscaled from HD source)
Supports Closed Captioning and Teletext
Connector: BNC (75 Ohm)
DVB-ASI
Standard: Asynchronous Serial Interface per EN500083-9
ASI Mirrored from DVB-ASI Input, IP Input, or RF Input with purchase of optional tuner package. All
streams are output as 188 byte packets.
Connector: Three BNC (75 Ohm)
AES Audio
Standard: AES3
4 pairs of decoded audio (pass-through audio is not supported on AES at this time)
Connector: Four BNC (75 Ohm)
Analog Audio
Two balanced pairs via DB9 connector. (1 pair per DB9)
Connector: Two DB9 (600 Ohm)
Communications
COM2 Serial Port
Use: API Serial Communication Interface
Default Baud Configuration: 38,400 bps 8 data bits 1 stop bit no parity
Connector: 8 pin RJ45
COM1 Serial Port
Use: Serial Port Used for Troubleshooting (Terminal)
Connector: 8 pin RJ45 (supplied with DB9 to RJ45 adapter)
Baud Configuration: 115,200 bps 8 data bits 1 stop bit no parity
Ethernet Port
Use: ethernet port used for network control, but can be used for IP receive
Format: Ethernet 10/100BaseT
Communication Methods: WebUI, SNMP, Telnet, XCP
Connector: 8 pin RJ45
DB9 Parallel Port
Use: DB9 parallel port used for custom triggering / integration
Connector: DB9 Male
GPIO Port
Use: not used as this time
Connector: DB9 Male
To Next Page
Loading...
