Genlock Status shows the state of the Genlock system.
Video Output is used for configuring the video outputs.
3G-SDI Mapping Level - SDI 3G Level controls the mapping of the 3G-SDI signal when
decoding 1080P50, 1080P59.94 and 1080P60 streams. The 3G-SDI signal can be mapped to
Level A or Level B Dual Link. The mapping is individually configurable for each set of outputs
(SDI and SDIALT). If 3G-SDI output does not appear on the downstream device, the device
may not support the currently configured mapping mode. Use SDI3GLEVEL to change the
mapping mode.
Down Scaling - The SDI out scale configuration controls the format of the SDI output
banks, SDI and SDIALT. Each bank has a unique configuration allowing simultaneous HD
and SD output. When set to OFF, the native resolution is output. When set to SD, the output
60
To Next Page
Loading...
