NETVANTA 5305 CONTROLLER P/N 1200831L1
Quick Start Guide
Quick Start Guide, 61200831L1-13B, July 2004 Technical Support 1-888-4ADTRAN (1-888-423-8726) © 2004 ADTRAN, All Rights Reserved
For more detailed documentation, visit us online at www.adtran.com
Commands
Refer to the ADTRAN Operating System (OS) Command Reference Guide
(provided on the system documentation CD) for details on configuring the
system using the CLI.
CONNECT THE CONSOLE INTERFACE
Before connecting to the NetVanta 5305 CONSOLE interface you will need
the following items: VT100 terminal or PC (with VT100 terminal emulation
software) and a straight through serial cable with a DB-9 (male) connector
on one end and the appropriate interface for your terminal (or PC) on the
other.
1. Connect the DB-9 (male) connector of your serial cable to the
CONSOLE port on the rear panel of the unit.
2. Connect the loose end of the serial cable to the VT100 terminal or PC
(with terminal emulation software).
3. Open a VT100 terminal session to the NetVanta 5305 using the
following settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit.
Press <Enter> to activate the ADTRAN Command Line Interface (CLI).
To Previous Page
Loading...
Need help?
General
