E
2
T QUASAR Flare Monitors Operation Manual General • iv
4.2 Power Connections ............................................................................................... 23
4.2.1 Service Markings .................................................................................................... 23
4.2.2 Protective Ground Connection ............................................................................. 24
4.2.3 Cover Attachment .................................................................................................. 24
4.2.4 Powering with 115 Volts AC∽ ............................................................................... 25
4.2.5 Powering with 220/230 Volts AC∽ ........................................................................ 25
4.2.6 Powering with 24 Volts DC .......................................................................... 25
4.3 Fusing ..................................................................................................................... 26
4.3.1 Mains ...................................................................................................................... 26
4.3.2 Heater ..................................................................................................................... 26
4.4 Connection for mA Output ................................................................................... 26
4.5 Connecting the Set Point Relay ........................................................................... 27
5 Operating the M8100PM-EXP ....................................................................................... 29
5.1 Start-Up Operation Checklist, Pilot Monitor (PM) .............................................. 31
5.1.1 Getting Started ...................................................................................................... 31
5.1.2 Initial Control Settings ........................................................................................... 32
5.1.3 Delay Setting .......................................................................................................... 32
5.1.4 System Gain/Climate Compensation ..................................................................... 32
5.1.5 Oscillation on the Analog Meter .......................................................................... 32
5.1.6 Noise Amplification ............................................................................................... 33
5.1.7 Relay Contacts ........................................................................................................ 33
5.1.8 Delay Adjust ........................................................................................................... 34
5.1.9 Milliamp Output (+mA / -mA) ............................................................................... 34
6 Operating the M8100FM-EXP ........................................................................................ 35
6.1 Start-Up Operation Checklist, Flare Monitor (FM) .............................................. 36
6.1.1 Getting Started ...................................................................................................... 36
6.1.2 Initial Control Settings ........................................................................................... 37
6.1.3 Delay Setting .......................................................................................................... 37
6.1.4 System Gain/Climate Compensation ..................................................................... 37
6.1.5 Oscillation on the Analog Meter .......................................................................... 37
6.1.6 Flare Monitor (FM) ................................................................................................. 37
6.1.7 Noise Amplification ............................................................................................... 38
6.1.8 Relay Contacts ........................................................................................................ 39
6.1.9 Delay Adjust ........................................................................................................... 39
6.1.10 Milliamp Output (+mA / -mA) ............................................................................... 39
6.2 Considerations for the Flare Monitor (FM) ......................................................... 39
7 Operating the M8100SM-EXP ....................................................................................... 41
7.1 Start-Up Operation Checklist, Smoke Monitor (SM) .......................................... 43
7.1.1 Getting Started ...................................................................................................... 43
7.1.2 Initial Control Settings ........................................................................................... 44
7.1.3 System Gain/Climate Compensation ..................................................................... 44
7.1.4 Set-point ................................................................................................................. 44
7.1.5 Relay Contacts ........................................................................................................ 44
7.1.6 Delay Adjust ........................................................................................................... 45
7.1.7 Milliamp Output (+mA / -mA) ............................................................................... 45
7.1.8 Final Steps............................................................................................................... 45
7.2 Considerations for the Smoke Monitor .............................................................. 45
To Next Page
Loading...