29
7. Flow Meters
inputs. These additional inputs are for tracking
input for additional tracking and alarm capabilities.
Select the Aux Flow Meter to set-up or review.
7.1 Flow Meter Setup
The Flow Meter setup gives the user access to the
of the current settings.
PULSE VALUE
contact, i.e. 225.
UNITS
i.e. Pulses / Ounce.
RESET TOTAL - Resets the totalized count of the
meter.
VERIFY ALARM -
RELAY LINK - The relay link informs the Aux meter input is relevant to the control function that the selected
linked to the relay that is driven by the feed timer that pump will be controlled by. If the Aux meter is going to
VOLUME ALARM - If FloTracker has been selected as the Tracking method, an alarm will occur when the
Note:
RESET VOLUME - Resets the Volume Alarm totalizer.
METER LINK – This selection only shows if the tracking method is Rate and Volume and tells the auxiliary
meter inputs. If this is selected, no wiring to the auxiliary input is required and the PULSE VALUE and UNITS
TRACKING - Provides a pop-up screen to select either FloTracker or Rate and Volume tracking.
To Next Page
Loading...
