41 Chapter 3
Please refer to the Data Mode (USDG Mode) to setup the Data Listen
Port, Command Listen Port, and Data Idle Timeout.
Hangup Character
The default character is “+”. After you have connected to another serial
device via ADAM-4570 series, you may need to disconnect. Then you
can use the command "+++" to disconnect. To do this leaves your key-
board idle (don't press any keys) for at least several seconds, then press
"+" three times. You can set "Guard Time" to define the idle time. Be sure
that you have to press "+" over the idle time.
Guard Time
The default value is 1000 ms.
Example: <Guard Time> + <Guard Time> + <Guard Time> +
The following commands are available for the ADAM-4570 series.
To Next Page
Loading...
