31 Chapter 3
DHCP Timeout(s)
If you select DHCP as IP configuration mode, the ADAM-4570 will retry
DHCP timeout(s) (default: 180s) until network settings are assigned by
the DHCP server. If the DHCP/BOOTP server is unavailable, the
ADAM-4570 will use Address auto configuration (based on RFC 3330
and RFC 3927) for IP setting.
3.4 Setting Serial Parameters
This section explains how to configure the ADAM-4570 series serial
communication parameters using this utility. There are various operation
modes that are suitable for different application.
Click on the "+" before the model name (e.g. ADAM-4571L), and the
utility will expand the tree structure to show the individual device name.
And click on the “+” before the device name, and the utility will expand
the interfaces on this device server. Select the serial interface (Port1).
Note When you have finished the configuration of these set-
tings for each category, please press the “Apply” button in
order to make these settings effective on the Serial
Device Server. (Will reboot your Serial Device Server)
To Next Page
Loading...
