Advantech ADAM-6251 Startup Manual

STARTUP MANUAL
1 Startup Manual
ADAM-6251
16-ch Digital Input Modbus TCP Module
Notes
For more information on this and other Advantech
products, please visit our websites at:
http://www.advantech.com
http://www.advantech.com/eAutomation
For technical support and service:
http://www.advantech.com.tw/eservice
This startup manual is for the ADAM-6251
Part No: 2003625100 1st Edition
February 2013
Switch Settings
It mainly presents the switch conguration for Dry Contact
and Wet Contact wiring in Digital Input interface.
Switch SW1 SW2
Position
1 2 3 4 1 2 3 4
DI Channel
Ch3 Ch2 Ch1 Ch0 Ch7 Ch6 Ch5 Ch4
Switch SW3 SW4
Position
1 2 3 4 1 2 3 4
DI Channel
Ch11 Ch10 Ch9 Ch8 Ch15 Ch14 Ch13 Ch12
ON
Dry Contact (Default)
OFF
Wet Contact
Overview
Thank you for purchasing this ADAM-6200 series
module.This is a quick guide to help you deploy the
ADAM-6200 series module in your application eld. It
will include power and application wiring. If you need a
more complicated or specic installation, you could try
to contact ADVANTECH for advanced technical support
or suggestions.
Input Power Requirements
The ADAM-6200 system is designed for a standard
industrial unregulated 24 V
DC
power supply. For further
applications, it can also accept +10 to +30 V
DC
of power
input, 200mV peak to peak of power ripple, and the
immediate ripple voltage should be maintained between
+10 and +30 V
DC
.
Application Wiring
Isolated Digital Input
Dry Contact
Wet Contact

Advantech ADAM-6251 Specifications

General

Model	ADAM-6251
Category	Control Unit
Digital Input Channels	8
Digital Output Channels	8
Communication Interface	Ethernet
Power Input	10 ~ 30 VDC
Digital Input Type	Sink/Source
Input Type	Dry Contact
Output Type	Sink
Protocols	Modbus TCP
Humidity	10 ~ 90% RH (non-condensing)
Input Voltage	10 ~ 30 VDC