Advantech ICAM-500 Series - Page 29

23 ICAM-500 Programming Guide
Chapter 4 CamNavi2 SDK API Manual
advcam_set_lighting_strobe_enable(cam, strobe)
Set LED lighting enable state.
Parameters: cam: ABSCamera
Camera instance.
strobe:
enable = 1
disable = 0
Returns: int
0: Success
See also:
HYPERLINK \l "iCam500.iCam500.set_lighting_strobe_enable()
advcam_get_img_brightness(cam)
Get camera sensor brightness.
Parameters: cam: ABSCamera
Camera instance.
Returns: int
Sensor brightness value.
See also:
iCam500.iCam500.get_img_brightness()
advcam_set_img_brightness(cam, brt)
Set camera sensor brightness.
Parameters: cam: ABSCamera
Camera instance.
brt
Brightness value.
init value = 100
range = [0..255]
step = 1
Returns: int
0: Success
See also:
iCam500.iCam500.set_img_brightness()
advcam_get_img_gain(cam)
Get camera sensor gain value.
Parameters: cam: ABSCamera
Camera instance.
Returns: int
Camera sensor gain value.