ADVATEK LIGHTING PixLite A4-S Mk3 - Connecting Pixel Leds

- 12 -
www.advateklights.com PixLite A4-S Mk3 User Manual V211013
5.4 - Connecting Pixel LEDs
A high level wiring diagram for connecting pixel LEDs to a PixLite A4-S Mk3 is shown in
Figure 8 below. Refer to Section 7.3 for the specific capacity of a pixel output.
Figure 8: Pixel Set up
The pixel lights are connected directly via the 4 pluggable screw terminal connectors
on the rear of the unit. Each connector is labelled with its output channel number (1-
4) which is clearly marked on the top surface. Simply wire your lights into each screw
terminal and then plug them into the mating sockets.
The cable length between the output and the first pixel should not exceed 15m.
Figure 9 shows the pin-out of the pixel output connectors.
Figure 9: Pixel Output Pinout - Expanded Mode Disabled