ADVATEK LIGHTING PixLite A4-S Mk3 - Operating Refresh Rates

- 22 -
www.advateklights.com PixLite A4-S Mk3 User Manual V211013
The hardware test requires that the pixel driver chip type and number of pixels per
output are set correctly in the Management Interface. Using Test mode, you can test if
this part of your configuration is correct and isolate other possible problems with the
incoming Ethernet data side.
7.7 - Operating Refresh Rates
The overall refresh rate of an installed pixel system will depend on many factors. For
monitoring purposes, graphical and numerical information on incoming and
outgoing frame rates can be viewed in the Management Interface. This information
gives insight as to what refresh rate a system can achieve, and where any limiting
factor may exist.
Refresh rates are available in the Management Interface for each of the following
elements:
l
Incoming sACN
l
Incoming Art-Net
l
Incoming DMX512 (Aux Port)
l
Outgoing Pixels
l
Outgoing DMX512 (Aux Port)