To Next Page

To Previous Page

Instruction for Cut off switch

1. The cut off switch is for when the winch is not in use.

2. Failure to disconnect the power to the winch could result in the following problems

A. If the winch is not periodically maintained the wiring could become loosened and cause difficulties.

B. When in use it is normal for the motor to generate some heat. If it has not been used for some time check contacts and

terminals for corrosion which will interfere with the current flow

C. When the winch has been in a moist environment, or stored for winter contacts may have become oxidised causing problems

D. Do not operate the winch under salty, chemical and gaseous conditions for any length of time or the electrical parts may be

affected

3. When you are about to use the winch make sure the control switches are in the off position before connecting the cut off switch

or cable.；

The function of the cut off switch is to

A. To prevent drainage of the battery

B.When not in use there will be no accidental operation of the winch

C,It can be used as an emergency cut off,

Note：

1,Do not use the cut off switch as a control switch

2,When using the winch make sure the cable is firmly connected

3,When not in use make sure the power is disconnected

• The cut off switch is to be turned off when the winch is not in use.

• If the winch is not periodically maintained the wiring could become loosened and cause

difculties.

• When in use it is normal for the motor to generate some heat. If it has not been used for

some time check contacts and terminals for corrosion which will interfere with the current

ow.

• When the winch has been in a moist environment, or stored for winter contacts may have

become oxidized causing problems

• Do not operate the winch under salty, chemical and gaseous conditions for any length of

time or the electrical parts may be affected

• When you are about to use the winch make sure the control switches are in the off position

before connecting the cut off switch or cable.

THE FUNCTION OF THE CUT OFF SWITCH IS TO

• To prevent drainage of the battery

• When not in use there will be no accidental operation of the winch

NOTE

• Do not use the cut off switch as a control switch

• When using the winch make sure the cable is rmly connected

• When not in use make sure the power is disconnected

9. INSTRUCTION FOR CUT OFF SWITCH

Adventure Kings DOMIN8R XTREME User Manual

Questions and Answers: